3 d

other times it just cranks. ?

Jun 26, 2009 · Possible failed crank position sensor. ?

The CPS wires can get get burned by the exhaust and short circuit. Cranks and cranks but won't start, is a symptom of a bad Crank Position Sensor (CPS) located on the transmission bell housing. I drove it home and it drove fine, and turned over all day I tested it like 15 times. - You sometimes will have No Bus on the odometer after 30-60 seconds. sig sauer p365 xmacro magazine This means that the CPS/CKP fails when engine gets hot, but works again when it cools back down. 1999 xj won't start The most likely cause of it cranks and cranks but won't start up is the Crankshaft Position Sensor (CPS) located on the transmission bell housing. Replaced that and the ignition switch and now the starter engages but the engine won’t turn over. The part is expensive ($200+), but you can just take it apart and clean it and it'll work fine, as long as nothing was broken/missing. That video link is for the 97 ZJ. craigslist used cars under 1000 near me Jump to Latest 3K views 10 replies 4 participants last post by Jerry Bransford Dec 1, 2021. Without the jeep running take a small screwdriver and push in on it slowly to make sure you have gas at the fuel rail from the get go. After a short while, had to go and there is all started. You should get a reading of If you are down in the. e rental public storage Not going anywhere, the Jeep won't do anything". ….

Post Opinion